Good Afternoon, I have a doubt about if is recommended mix interface type (SVI, subinterface) for L3OUT in the same node (obviously in different L3OUT´s)? I think it could be a misbehavior but I'm not sure. Does somebody help me? Many Thanks!!
Forum Posts
Hi experts,Have anyone interconnected 2 ACI Fabric using L3Out? Are there any difficulties or caveats? We have 2 separate Fabric, we want to bring up a dark fiber to interconnect the Border Leafs, establish routing between these 2, we do not need L2 ...
I would like to cable a customer switch into the ACI leaf node. I have a hypervisor physical system cabled to the leaf node as well. I would like to set up an L2OUT between these two so that they can communicate on a shared IP address space. Should I...
I was asked for this question below and I do not know the answer... What would be the downside of using 0.0.0.0/0 as the external network subnet for all the L3Out external EPGs? Here is some background information related (to keep thing simple, lets ...
Hi everyone, I am trying to Deploy a service graph that will load balance traffic to a certain EPG between to proxies.The traffic to the EPG is redirected to the proxies, but the problem is that it arrives with the destination address of the EPG endp...
I'm looking for feedback to decide between two approaches to using ACI to organize legacy VLANs/subnets.I'm designing a higher-ed ACI deployment, migrating away from a FabricPath environment. In legacy, we operate everything in a single N7k VRF / VD...
Resolved! ACI VMM migrating existing VDS
We currently have vmware ESX VDS setup using static port EPGs. We'd like to move all our static EPGs over to new VMM VDS. Is it possible to create a new VMM vlan pool with new dynamic EPGs as well as existing static EPGs? This means we'll have the s...
Resolved! ACI legacy trunk
Hello, Apologies in advance if this question has been asked before, I just have managed to get a mental block.We will be connecting a new (network centric) ACI network into our existing catalyst core which is currently VSS but will be split in the ...
Resolved! ACI - Default Gateway Question
Hello, in a given ACI Design we are following the network centric approach. The "old" VLAN structure ist mapped to One BD = one EPG = one Subnet The default gateway for all BDs should be the firewall. In our case there are around 50 BDs My question...
Does Anycast gateway & Pervasive gateway in ACI is same ? What I feel its same. Please make me correct if I am wrong.
Hi Experts,I have the following scenario. There are two pairs of firewalls in active/standby HA. One pair is used to filter east-west traffic and the other pair is used for north-south traffic.E-W traffic:Currently, a E-W PBR contract is applied on v...
Devnet APIC always-on sandbox has not been available for 1 week? Will it be up again and when?
Hi , I have a case where I need to leak between an EPG connected to a VRF-internet that provides internet access through F5 , while VPN access is provided through another VRF-VPN I need to Leak the EPG sub-net from vrf-internet to vrf-VPN L3out EPG ,...
Hi team, I can’t register APIC with CSSM on-prem. I used a command on APIC CLI: apic(config)# license smart transport-mode on-prem url <URL was collected from the software itself> I monitored and the license is still not updated. Connection from APIC...
In what scenario does 'api/node/class/epmIpEp' API return 'unspecified' for ifid?My understanding is that 'ifid' is the name of the interface on the leaf interface to which End point in question is connected.Please help me understand if this value ca...
