Cannot see end points via cli

[Leftz]

Hi There are several endpoints in ACI like the below, but when entering command "show mac access interface switch 101", it show all interface are disabled /down, what happen? I guess it might be virtual endpoints. Its possible to setup virtual one like below? Thanks

[Ruben Cocheno]

@Leftz 

Check if the command below suits you

apic1# fabric 101 show mac address-table

[Leftz]

Hi Thanks!

Please the below. Looks like there are not end points under fabric. but why we really can see these several end points via gui? Not sure if these end points are virtual one or somthing else?