Hi,
I'm trying to connect to cable between APIC-SERVER-L2(VIC1225 with 10GBASE-T) and C93108TC.
The SFP vender is the Interlink.
A link of C93108TC is up but, APIC's side is down.
Is link possible to be up ?
apic1# cat /proc/net/bonding/bond0
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth2-1
MII Status: up
MII Polling Interval (ms): 60
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth2-1 => 10G-SR
MII Status: up
Speed: 10000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr:
Slave queue ID: 0
Slave Interface: eth2-2 => 10G-T
MII Status: down
Speed: Unknown
Duplex: Unknown
Link Failure Count: 6
Permanent HW addr:
Slave queue ID: 0
admin@apic1:~> ethtool eth2-2
Settings for eth2-2:
Supported ports: [ FIBRE ]
Supported link modes: 10000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Supported FEC modes: Not reported
Advertised link modes: 10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: No
Advertised FEC modes: Not reported
Speed: Unknown!
Duplex: Unknown! (255)
Port: FIBRE
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Cannot get wake-on-lan settings: Operation not permitted
Current message level: 0x00000000 (0)
Link detected: no
<C93108TC>
show interface status
Eth1/48 -- out-of-ser trunk full 10G 10g
thank you
best regards
