08-11-2021 07:46 AM
Hi All,
is there any chance to acknowledge faults port-wise? My intention is to acknowledge some port down Faults. As some sleeping servers are connected to those ports, removal of port config is not possible but I want to get rid of the corresponding faults.
Thanks.
BR
Solved! Go to Solution.
08-12-2021 06:18 AM
Only the specific fault which is ack will be hidden. And since the fault refers to a specific interface in a specific EPG, only that one will be hidden. If you have the same interface in multiple EPGs, then you'll need to ack all faults.
Cheers,
Sergiu
08-11-2021 08:40 AM
Hi @Chris77
You can to ack only the specific faults you want, by going to the System -> Faults -> select the fault you want to ack, right click on it and select Acknowledge fault:
Then you can go back to the Faults repository, click on the hammer logo and select Hide Ack Faults:
You have this option in Dashboard as well:
Cheers,
Sergiu
08-12-2021 12:52 AM
Thanks @Sergiu.Daniluk.
But does this means that the fault is acknowledged in general for the whole landscape or only for this specific port?
08-12-2021 06:18 AM
Only the specific fault which is ack will be hidden. And since the fault refers to a specific interface in a specific EPG, only that one will be hidden. If you have the same interface in multiple EPGs, then you'll need to ack all faults.
Cheers,
Sergiu
08-12-2021 07:07 AM
Thank you Sergiu.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: