cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1743
Views
5
Helpful
3
Replies

Possible to enable LLDP or CDP on Leaf uplink interfaces

mr-steveb
Level 1
Level 1

hi all,

 

I'm trying to understand whether it's possible to enable LLDP or CDP on the fabric interfaces, i.e. the interfaces that connect the leaves to the spine.

 

I'm trying to use a Solarwinds Orion Maps and it doesn't detect the connection perspective, as I believe it depends on SNMP to poll the relevant CDP/LLDP OIDs.

 

I can see it's possible to enable cdp and lldp on access ports within ACI and that all works fine, but can't figure out if it's possible to do so on fabric ports.

 

cheers!

 

Steve

3 Replies 3

Sergiu.Daniluk
VIP Alumni
VIP Alumni

LLDP is enabled by default on fabric ports.

Leaf1201# show lldp ne interface e1/54
Capability codes:
  (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device
  (W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
Device ID            Local Intf      Hold-time  Capability  Port ID  
Spine1101             Eth1/54         120        BR          Eth1/24         

Cheers,

Sergiu

Thanks Sergiu, 

 

Yeah I made an error in mentioning LLDP, I can see indeed that LLDP is available, however for some reason Solarwinds isn't picking up LLDP information via SNMP, only CDP seems to get picked up.

 

Is it possible to enable CDP between fabric interfaces? 

 

Cheers

 

Steve

Hi Steve, 

Its not possible to enable CDP between fabric connected interfaces.

Review Cisco Networking for a $25 gift card

Save 25% on Day-2 Operations Add-On License