ACI Configuration of port channel

[cnogueral]

A client has aci infrastructure. they currently require port channel configuration from the two nexus leaf switches to dell servers
There is some recommended guide on how to perform all the configuration from the APIC by graphical interface, the interfaces, assign the vlan and create the epg

[PatrickH1]

Hi,

are the Leafs registered in the Fabric, if not perfrom this in the first step:

- Register to Fabric
o Fabric -> Inventory -> Fabric Membership
- Assign MGMT-IP
o TN-MGMT -> Node Management Addresses -> Static Node Addresses
- Assign TACACS
o Add new ACI Host to TACACS -> ISE/ACS etc....
- Upgrade Software if necessary
o Admin -> Firmware -> Fabric Node Firmware -> Firmware Group
 Necesarry to assign correct Target Firmware
o Admin -> Firmware -> Fabric Node Firmware -> Maintanence Group
 Necessay to upgrade Firmware
- Add Descriptions
o Connect to every Leaf and add Description to every Port
- Configure VPC Protection Group
o Fabric -> Access Policies -> Switch Policies -> Policies -> VPC default
- Configure Leaf Profile
o Fabric -> Access Policies -> Switch Policies -> Proflies -> Leaf Profles
 Add one Profile for every Leaf and one for Pair of Leaf acting in VPC
- Configure Interface Lead Profile
o Fabric -> Access Policies -> Interface Policies -> Profiles -> Leaf Profles
 Add one Profile for every Leaf and one for Pair of Leaf acting in VPC

Don't forget to mark answers as correct if it solves your problem.

Kind Regards

Patrick