cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

441
Views
10
Helpful
3
Replies
ChrisMac70330
Beginner

ACI L3OUT using SVI.

Hi guys,

 

I would be interested that when doing a L3OUT with Static Routing to 2x FW with SVI , I can create 2 VPC with the same Secondary(Virtual IP node) on 2 Border leafs with the same Vlan Encapsulation.

This would be done using SVI: with the same IPs and the same vlan Encapsulation

The setup would look similar to this : 

 

Under Logical Node Profile:

VPC 1 Side A IP 10.0.0.2/28 Side B IP : 10.0.0.3/28 Secondary IP: 10.0.0.1/28  vl 10

VPC 2 Side A IP 10.0.0.2/28 Side B IP : 10.0.0.3/28 Secondary IP : 10.0.0.1/28 vl 10

 

Is this setup supported by ACI?

Thanks.

 

 

3 REPLIES 3
RedNectar
Engager

@ChrisMac70330 ,

 

If you doing 

Static Routing to a FW with SVI

as you say you are, then you only need one VPC and your configuration design:

Under Logical Node Profile:

VPC 1 Side A IP 10.0.0.2/28 Side B IP : 10.0.0.3/28 Secondary IP: 10.0.0.1/28  vl 10

..is perfectly correct

If you are connecting to two firewalls, it is a different story...

I hope this helps

 



Don't forget to mark answers as correct if it solves your problem. This helps others find the correct answer if they search for the same problem


 

RedNectar
aka Chris Welsh


Don't forget to mark answers as correct if it solves your problem. This helps others find the correct answer if they search for the same problem

Yes, I am connecting two FW. 

Does this help?

https://unofficialaciguide.com/2017/08/03/l3out-connecting-to-activestandby-fw/

Not using VPCs though - still uses the SVI concept

 

RedNectar
aka Chris Welsh


Don't forget to mark answers as correct if it solves your problem. This helps others find the correct answer if they search for the same problem

Content for Community-Ad
This widget could not be displayed.