cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
418
Views
15
Helpful
2
Replies
vv0bbLeS
Beginner

ACI Leaf - how to "undebug" ?

Hello all,

On one of my leaf switches I have run the command debug system internal epm trace detail which I guess sets a debug level on the leaf. Is there a way to "undebug" or "no" this command to turn it off now that I'm done with it? I can't seem to find any documentation on the Cisco ACI Leaf debug levels or how to "undebug" commands like the above.

 

Thanks!

0xD2A6762E
1 ACCEPTED SOLUTION

Accepted Solutions
Robert Burns
Cisco Employee

Hopefully you enabled the debug via vsh command.  If so, you can disable it with:

vsh -c "debug system internal epm trace default"

Robert

View solution in original post

2 REPLIES 2
Robert Burns
Cisco Employee

Hopefully you enabled the debug via vsh command.  If so, you can disable it with:

vsh -c "debug system internal epm trace default"

Robert

View solution in original post

@Robert Burns  I was following this Cisco .pdf presentation which actually has you run it at the regular leaf1# prompt and also via vsh_lc -c , but nothing with vsh.

 

Will running the vsh command above work if I ran the debug command at both of the above prompts?

0xD2A6762E