01-17-2018 01:43 PM - edited 03-01-2019 05:25 AM
Hi everyone,
How does ACI handle link flap? Is it possible to configure parameters to err-disable a link after certain parameters?
One of the link is causing issue and not failing over to the redundant link.
Really would appreciate your help.
Kind regards,
Shahin
01-17-2018 02:49 PM - edited 01-17-2018 03:09 PM
Is that link part of a port channel? Also you can set up an interface policy to err disable a port after so many errors, but it won't re-enable the interface again. You can also configure a Monitoring Policies
If this is port of a port-channel and the other interfaces are working you it may be a physical cabling or SFP issues. Also you can do a show interface or show interface transceiver to see the errors on that interface. If there is a high amount of CRC's errors you may need to replace the cable and SFP transceiver.
This is a good link for the monitoring policies.
01-17-2018 02:51 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide