cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
5
Helpful
2
Replies
Highlighted
Beginner

ACI Multi-Pod 10G to IPN using 9332C

Can anyone confirm if the 9332C ACI spine switches support connection to IPNs using the two on-board 10G SFP+ interfaces?

Anyone had any experience setting this up? Can't seem to find any validated info on this except for using QSA breakout cables on main ports, but I remember seeing this as possible prior to these switches being released, but nothing since in any whitepapers.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

Re: ACI Multi-Pod 10G to IPN using 9332C

Hi @newtonr 

Indeed, there is no documentation about this, but it is supported.

Apply the IPN policies on interfaces 1/33-34, which are the 10G ports.

 

Regards,

Sergiu

View solution in original post

2 REPLIES 2
Highlighted
Rising star

Re: ACI Multi-Pod 10G to IPN using 9332C

Hi @newtonr 

Indeed, there is no documentation about this, but it is supported.

Apply the IPN policies on interfaces 1/33-34, which are the 10G ports.

 

Regards,

Sergiu

View solution in original post

Highlighted
Beginner

Re: ACI Multi-Pod 10G to IPN using 9332C

Thanks for the confirmation Sergiu.