cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

ACI Standby Controller with state of Do Something

brian.holmes
Beginner
Beginner

We recently added a couple standby controllers to our environment.   Their state in the GUI says is "Do Something".    Should we just leave them in this state or should we hit the Accept Controller button for them?  Will the standby controllers pick up new firmware updates in the "Do Something" state?  The one in an approved state was an active controller previously, but the other two are new.

 

StandbyAPIC.PNG

Brian Holmes
Verizon
0 REPLIES 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: