01-26-2021 04:56 AM
Hi,
In ACI, can we run vPC using two different model - e.g, N9K-C93108TC-EX and N9K-C93108TC-FX.
I saw in documentation that this is not possible in NXOS, not sure about ACI.
Thanks !
Eng We
Solved! Go to Solution.
01-26-2021 05:23 AM - edited 01-26-2021 05:39 AM
You can't mix Gen1(-E) & Gen2+(-EX, -FX*) switches in a VPC pair. Officially, we support EX & FX in the same VPC pair, but personally I would caution against this and try at all times to keep VPC members as the same Generation (EX & EX, FX & FX) - primarily due to certain features requiring particular generation of switch (Ex. MacSec, Telemetry etc).
Under "Virtual Port Channels" Section.
Robert
01-26-2021 05:15 AM
You can mix the models high level.
01-26-2021 05:23 AM - edited 01-26-2021 05:39 AM
You can't mix Gen1(-E) & Gen2+(-EX, -FX*) switches in a VPC pair. Officially, we support EX & FX in the same VPC pair, but personally I would caution against this and try at all times to keep VPC members as the same Generation (EX & EX, FX & FX) - primarily due to certain features requiring particular generation of switch (Ex. MacSec, Telemetry etc).
Under "Virtual Port Channels" Section.
Robert
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide