Hello, With ACI verion 4.2(i) and vCenter 6.7, I'm trying to install Cisco AVE in the vCenter. I followed the steps in the "Cisco ACI Virtual Edge Installation Guide, Release 2.2(x)", but when I get to "Cisco ACI Virtual Edge Installation Using the ...
Hi What should the Consumer Connector BD be set to for L3Out EPG when applying a Service Graph Template? I will explain with an illustration... This is for a unmanaged Service Graph Template for a vADC. Policy is to insert a vADC for Client traffic c...
Hello Guys, I'm trying to configure the APIC Simulator in order to execute some tests on ACI infrastructure.I properly configured the OoB IPs during the initial setup and i'm now able to reach all the 3 APICs. Anyway, i would like to extend also the ...
Hi, In a lab environment the only APIC crashed without any known reason (so far..)and we had to restart it. After that all seems to work well except the VMM Vcenter integration. The faults we get are: F16438[FSM:STAGE:RETRY:]: Connect stage for VM ...
I found two different theory to handle l3 traffic for unknown IP in ACI one is stated below which is from White Paper 739989 and in other cisco live document I have seen that this will be treated via spine proxy method. "For (L3) routed traffic to an...
I found below note in cisco white paper i.e 739989 - end point learning but unable to understand it. "An exception exists for remote MAC address learning when a packet is incoming from L3Out to Cisco ACI. If ARP traffic is coming from an L3Out SVI ra...
Hi All, Spine Leaf designs I have seen so far show a single link from Leaf to each Spine and the recommended solution to increase aggregate fabric throughput is to add another Spine. Is it a valid design to have multiple links from Leaf to Spine to a...
Dears ,Please check as the ACI sandbox does not accept any simple action on it from yesterday ? even creation of a tenant returns "Error: 400 - the messaging layer was unable to deliver the stimulus (connection error, Connection refused)"
Hi!I need some support to understand if a PBR is an EW traffic PBR or NS in a Multi-Pod deployment.- EW: Traffic intra VRF in on Tenant- NS: Traffic going outsite the ACI I have one VRF "A" on Common Tenant with some "common services epgs" using a C...
On my classical network I have two switches with connections to 2 sets of HA Pair of firewalls( Palo) The connection is made via a subnet we can data transport, It's just a /24 network. On the switches I have an SVI for data transport and we run ...
Hi, Will like to check if I had 1 L3Out but BGP peer to different ISP (A & B). But when advertise route, I only want to advertise all to ISP A instead of ISP B, is this workable? Or I will need to create another L3Out for ISP B? In IOS, we can create...
Greetings, out of curiosity how long does it take your APIC device to boot to the APIC screen?I'm seeing anywhere from 20-30 minutes. Sometimes requiring me to reboot multiple times to get it to appear.Working with C220 M5. More often then not I get ...
Hello, Currently, I am designing ACI objects for ACI. For AAEP I was following best practice, one AAEP for each tenant with different domains for each tenant. In my network, I have about 10 tenants. Some of the physical interfaces are shared between...
I see that licensing is introduced in release 3.2(1l). I also found a following note: "If the APIC is unregistered, the APIC functionality is not affected." Not sure what is the purpose? I'd like to get rid of that annoying alert caused by not licens...
Hi all,After change booting setup (F2) to "Load manufacturing Default values"My APIC can't boot up
