Cisco ACI EP to EP details

[manse0081]

Hi

In Cisco ACI setup how to monitor Endpoint to Endpoint (source to destination) traffic Utilization.

Same EP vlan to others EP Vlan.

I want to check Endpoint to Endpoint traffic Utilization and 

Regards

Asif 

[Sergiu.Daniluk]

If what you are looking for is to have statistics and historical data about all Ep-to-Ep trafffic (similar to EPG egress/ingress stats), well there is no APIC built-in tool which can give you that. For this, you can change your ACI leaves to Netflow or Telemetry mode to export flow statistics and analysis. 

If however you only need it during a troubleshooting session for example, you can use Visibility and Troubleshooting tool, from Operations menu.

Hope it helps,

Sergiu

[manse0081]

Thanks 

[Gaurav Gambhir]

you can use on-going atomic counters if you are just interested in stats, refer to ::

https://www.cisco.com/c/en/us/support/docs/cloud-systems-management/application-policy-infrastructure-controller-apic/119418-config-atomic-00.html#anc8

[Sergiu.Daniluk]

Just to avoid confusion, ongoing atomic counters are not user configurable and they count TEP-to-TEP packets - the source and destination of the flow are TEP IP addresses.