cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
734
Views
0
Helpful
2
Replies

Fault suppression for unused interfaces in ACI version 3.2(3) - Low Health score issue

amitgami
Level 1
Level 1

Hi,

 

I have ACI fabric version 3.2(3n) deployed and have many unused interfaces in the initial deployment. This is dragging the overall Fabric health down. Referred to the following document to suppress fault

 

How ACI faults are generated and how to selectively prevent faults from being generated

 

However, there is no option to edit Fault severity assignment policies. Screenshot attached. Is this a bug? Can anyone else see the edit option on this page? 

 

thanks,

2 Replies 2

micgarc2
Cisco Employee
Cisco Employee

Are you getting faults? If so, why not just disable (black-list) the interface if you are not using it?

Yes, that is an option that is currently used. However, the customer has requested to keep all the ports enabled and the only solution is to set the fault severity, as shown in the document, to be disabled for disconnected access ports. The issue is this setting is not even configurable in the current version. Thus, checking if this is a bug that needs to be registered in version 3.2(3n)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Save 25% on Day-2 Operations Add-On License