Faults persist for decommissioned switches

[DanLaden]

ACI 4.1(1L)

I have a fabric where I added a spine and leaf for a short time and then decommissioned/removed said switches.

While present, some faults were raised on the switches and did not clear when the switches were removed.  I do not see it listed under registered nodes, nodes pending registration, unreachable nodes, nor decommissioned switches.

How does one clear faults associate with non existant switches? 

F1295
minor
Raised
topology/pod-1/node-1002/local/svc-policyelem-id-0/uni/fabric/time-default/issues
Fault delegate: Datetime Policy Configuration for default failed due to : provider-is-not-present-under-default-pol
Config
configuration-failed
configQual:provider-is-not-present-under-default-pol, configSt:failed-to-apply

F1700
minor
Raised
topology/pod-1/node-1002/sys/time
Fault delegate: Ntp configuration on spine SP1001 is Not Synchronized
Operational
protocol-ntp-sync-failed

[Remi Astruc]

Hello,

Try to ignore the Fault for one minute.

To do so, right-click the Fault and "Ignore Fault". Then revert the change by finding the created Fault Severity Assignment Policy and deleting it.

Check if Fault is still there.

Remi Astruc

[DanLaden]

This did not have an impact.  Had the faults suppressed for upwards of 6 minutes.

Thank You,

Dan Laden