High Wrong Area on OSPF Traffic

[sandyblaza]

Hi,

I've encountered a high counter on Wrong area. I don't know what the meaning of it, what its cause and do this a sign I got wrong configuration or setup , please see the show command below:

ACILP01# show ip ospf traffic vrf Tenat1:VRF1_VRF

OSPF Process ID default VRF Tenat1:VRF1_VRF, Packet Counters (cleared 3d21h ago)
Total: 115888 in, 39477 out
LSU transmissions: first 345, rxmit 6, for req 6 nbr xmit 0
Flooding packets output throttled (IP/tokens): 0 (0/0)
Ignored LSAs: 0, LSAs dropped during SPF: 0
LSAs dropped during graceful restart: 0
Errors: drops in 0, drops out 0, errors in 28745,
errors out 0, hellos in 28745, dbds in 0,
lsreq in 0, lsu in 0, lsacks in 0,
unknown in 0, unknown out 0, no ospf 0,
bad version 0, bad crc 0, dup rid 0,
dup src 0, invalid src 0, invalid dst 0,
no nbr 0, passive 0, wrong area 177347,
pkt length 0, nbr changed rid/ip addr 0
bad auth 0, no vrf 0

hellos dbds lsreqs lsus acks
In: 113805 24 6 1019 1034
Out: 38591 27 7 357 495

And I have multiple tenants each has own VRF and L3Out. I'm running all of OSPF on a single vpc port.

[Francesco Molino]

Hi

Never seen it before but i only installed 1 aci with ospf. All others uses bgp.

Anyways, did you check the configuration to make sure there's no mismatch area configuration? Is this appearing on other vrfs as well?

[sandyblaza]

I'd checked the configuration of my tenants, the area was correctly configured. 

[Francesco Molino]

I don't know your config and i would recommend to contact TAC

[sandyblaza]

Hi,
I leave it that since my network work... I want to know now if I could clear it... Thanks :)