How to propogate new configuration into Spine and leaf after wiping APIC controller Cluster

[eahmed007]

Dear All ,

We have wiped out all 3 APIC Clusters and configure 3 APIC Cluster from scratch  and replace the backup configuration and We are trying to add all configuration manually .However , We have noticed that all Spine and Leaf is still having old database as we are not able to push policy to leaf and spine  as Spine and Leaf having earlier configuration .

Should we reboot each Sipne an leaf switch to propagate  new configuration .

Please assist us to overcome the problem  and expecting your valuable comments on this issue.

With regards

Erfan

[Nik Noltenius]

For a new, clean setup you also have to reset the leaf and spine switches. It's a simple process described step-by-step here:

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/troubleshooting/b_APIC_Troubleshooting/b_APIC_Troubleshooting_chapter_01001.html