cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

870
Views
0
Helpful
2
Replies
p.hruby
Beginner

Spine/leaf cabling rules

Is it possible to add a new spine into the existing fabric even if the spine is not conected to all leaves? I know this is not a valid design but I'd like to know if this works. Is there a document which describes ACI behaviour when some cables are not connected between spine and leaves? For example when path from a source leaf to a target leaf must go over an another leaf (source leaf - spine1 - leafX - spine2 - target leaf) because of improper (faulty) cabling between source/target leaves and spines.

2 ACCEPTED SOLUTIONS

Accepted Solutions

As per my knowledge you can add the spine as you mentioned. only the thing
is its not recommended way and its working fine.

View solution in original post

Remi Astruc
Beginner

2 REPLIES 2

As per my knowledge you can add the spine as you mentioned. only the thing
is its not recommended way and its working fine.

View solution in original post

Remi Astruc
Beginner

Content for Community-Ad