We have deployed 2 identical fabrics in 2 different locations, both of them have an external connection to a pair of C4500 via VPC
The VPC to the C4500 has 22 VLANs allowed on the connection, it was working fine during staging and when the devices were moved to their final location and powered up again we noticed the VPC was missing 10 VLANS
The configuration is still there, the APIC has no configuration faults, but the VLANs simply won't show up on the trunk!
Let me start by telling you that there is already a very nice document in the Cisco Community Forums which describes the procedure to upgrade the APIC CIMC. In case you came across this document before looking into the mentioned one, here is...
2020年7月14日 (初版)主な問題F3 ラインカードを利用した場合、Shared Policers の設定により通信レートを期待値に制御できません。CIR 値を 1048600 に設定し、以下一例となります。128 byte のペイロードのパケットが通過している場合の、egress port 側の sh int の出力：N7K(config)# sh int e1/1 | i i rate
Rate mode is dedicated
30 seconds input ...