cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
135
Views
0
Helpful
4
Replies
Highlighted
Participant

What does this error mean in ACI 4.2(1l)?

I did two snapshots for a particular tenant and all Fabric respectively. When I try to rollback either snapshot, it got this "warning" message...

Capture1.JPG

 

But what does it really trying to tell me...?? The configuration was not rolled back either...

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: What does this error mean in ACI 4.2(1l)?

probably your IP SLA monitoring policy to TCP, however TCP port suppose to be non-zero. you can also set the IP SLA monitor policy to ICMP to get around this error.

View solution in original post

4 REPLIES 4
Cisco Employee

Re: What does this error mean in ACI 4.2(1l)?

probably your IP SLA monitoring policy to TCP, however TCP port suppose to be non-zero. you can also set the IP SLA monitor policy to ICMP to get around this error.

View solution in original post

Participant

Re: What does this error mean in ACI 4.2(1l)?

I will check the default policy. I didn’t create one myself...

Participant

Re: What does this error mean in ACI 4.2(1l)?

The default IP SLA policy under common tenant was the cause...It was configured as below. But why it was set to TCP with destination port as 0 by default then? I did not modified it but I did upgrade the Fabric from really old version to version 4.2 in steps though? So is it a bug then?

 

Capture.JPG

Cisco Employee

Re: What does this error mean in ACI 4.2(1l)?

at least in couple of fabric in two different 4.2 versions I see default is ICMP.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards