03-31-2009 08:03 AM
Greetings:
I have an ACE module that is load balancing a pair of AVS 3120 devices. I want to create a probe to monitor the AVS devices to remove them if they fail to perform. Does anyone have a recommendation of the best practice for the probe design? Currently I am monitoring the AVS devices on port 80 but I do not know if âport 80 is aliveâ is the best way to check these devices. Any recommendations on AVS monitoring is greatly appreciated.
04-07-2009 06:08 AM
Not sure if you've seen this link but it might help...
04-07-2009 06:23 AM
I had not seen that link. Thank you for your input. The document mentions cisco_avs_parametermap, I will need to research this setting to see if it applies to the external AVS devices.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: