12-29-2009 01:00 AM
hi,
i try to configure HTTP health probe at ACE 4710 , software version A3(2.3) but i found the following :
Previous versions:
Request method: N/A, GET, Head
In version A3 (2.3)
Request method: GET, Head
why they remove N/A option ?
please find attached image
best regards,
Solved! Go to Solution.
12-30-2009 08:05 AM
Configure the following under the probe :
header Host header-value www.ccie.com.sa
Gilles.
12-29-2009 11:00 AM
what was the N/A doing for you ?
It's either GET or HEAD.
Also, is this a GUI issue only ?
Gilles.
12-29-2009 09:31 PM
the following configuration was working before, but know it is not :
probe http app-http
port 80
interval 15
faildetect 10
passdetect interval 2
passdetect count 1
expect status 200 201
open 10
can you please tell how to configure http health probe for the following site using get method (as example):
best regards,
12-30-2009 12:59 AM
I configured your probe :
probe http http1
interval 15
faildetect 10
passdetect interval 2
passdetect count 1
expect status 200 201
And then checked the result
switch/Admin(config-probe-http)# do show probe http1 de
probe : http1
type : HTTP
state : INACTIVE
description :
----------------------------------------------
port : 80 address : 0.0.0.0 addr type : -
interval : 15 pass intvl : 2 pass count : 1
fail count: 10 recv timeout: 10
http method : GET
http url : /
conn termination : GRACEFUL
expect offset : 0 , open timeout : 10
expect regex : -
send data : -
--------------------- probe results --------------------
probe association probed-address probes failed passed health
------------------- ---------------+----------+----------+----------+-------
serverfarm : vmware-http
real : vmware-27[80]
192.168.40.27 0 0 0 INIT
Socket state : RESET
No. Passed states : 0 No. Failed states : 0
No. Probes skipped : 0 Last status code : 0
No. Out of Sockets : 0 No. Internal error: 0
Last disconnect err : -
Last probe time : Never
Last fail time : Never
Last active time : Never
As you can see, the default method is GET and the default url is /
Again, there is no method N/A. Since there is a default value it is normal to see it and not N/A.
Check the last status code (in red above) to see what is the server response code.
Give us the output of the show probe detail if you can't figure out the reason for the failure.
Gilles.
12-30-2009 02:37 AM
thanks for your help
I just noticed that I am getting status code 404 page not found because the web server (IIS) configured to listen to Name only not to ip address
if ip put : www.ccie.com.sa : it is working
if ip put: 192.168.198.1 : it is not working
can i put the complete URL in get request like the following :
/www.ccie.com.sa/
best regards,
12-30-2009 08:05 AM
Configure the following under the probe :
header Host header-value www.ccie.com.sa
Gilles.
01-03-2010 12:36 AM
Thank you very much
it is working fine now
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide