Hi all,
I configured SSL accelerated services for a device group where are two data center WAEs in CM WAE GUI. I imported key and certificate and then I clicked on the Submit button. When I checked both data center WAEs there are no CLI configuration for SSL acceelerated services (ip address of server and port 443).:-( Only one crypto command is shown in running config on both WAEs: crypto ssl services global-settings. I have SSL acceleration enabled on both WAEs and secure store is open on all WAEs (CM WAE, DC WAEs and branch WAEs). Do you have any solution for this situation?
See:
sho run | inc 10.1.1.1 - the address of SSL server, this server is configured in the CM WAE GUI with port 443.
- no configuration in CLI for this address:-(
sho run | inc crypto
crypto ssl services global-settings
sho accelerator ssl
Accelerator Licensed Config State Operational State
----------- -------- ------------ -----------------
ssl Yes Enabled Running
SSL:
Policy Engine Config Item Value
------------------------- -----
State Registered
Default Action Use Policy
Connection Limit 18000
Effective Limit 17900
Keepalive timeout 5.0 seconds
sho cms secure-store
Secure-store is initialized and open.
sho crypto ssl services accelerated-service - there is no configuration:-(:-(
Accelerated Service Config State Oper State Cookie
------------------- ------------ ----------- ------
sho crypto ssl services host-service peering
Peering service state: ACTIVE
Thanks
Roman
