03-06-2014 03:29 PM
Hi All,
I have a 2921 with an 16port Ether Switch module and need to install the SM-SRE 710 for WAAS.
on the 2921 G0/1 is the WAN 10.1.1.1 and the internal port G1/0 is LAN 10.1.2.1
How do I assign the IP addresses to SRE module so that I can use WCCP to direct traffic to correct interface.
Or is this not possible with ESM already installed.
Solved! Go to Solution.
03-27-2014 08:58 AM
Hi,
I would expect this to work fine.
Via the SM<slot>/0 interface you configure both the router-side IP address ("ip address ..." command) as well as the WAAS side IP address ("service-module ip address ...") and the WAAS side default gateway ("services-module ip default-gateway <router-side IP address>"). You should use a subnet here, which isn't used anywhere else in your network. Please also see here:
http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/ism-sm-sre.html#wp1140891
For being able to configure WCCP redirection, that's all what is required. Of course, you should also adapt routing in your networkf to ensure the new subnet is reachable, so you can reach WAAS on the SRE for management purposes (including management from a WAAS CM).
On WAAS side you would then give the router-side IP address of the SM<slot>/0 interface in the WCCP router list.
Regards,
Michael
03-27-2014 08:58 AM
Hi,
I would expect this to work fine.
Via the SM<slot>/0 interface you configure both the router-side IP address ("ip address ..." command) as well as the WAAS side IP address ("service-module ip address ...") and the WAAS side default gateway ("services-module ip default-gateway <router-side IP address>"). You should use a subnet here, which isn't used anywhere else in your network. Please also see here:
http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/ism-sm-sre.html#wp1140891
For being able to configure WCCP redirection, that's all what is required. Of course, you should also adapt routing in your networkf to ensure the new subnet is reachable, so you can reach WAAS on the SRE for management purposes (including management from a WAAS CM).
On WAAS side you would then give the router-side IP address of the SM<slot>/0 interface in the WCCP router list.
Regards,
Michael
03-30-2014 11:45 PM
Both,
As the 2921 is only capable of having one service module, I thing that you'll run into other problems, than just assigning IP-addresses.
You cannot have both a SRE-710 and a 16 port Etherswitch module in a Cisco 2921.
Best regards
Finn
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide