We are looking to deploy a WAAS solution with the branches connected via 10Mb Ethernet services terminated on Cisco 2911's. We are looking to include WAE-502-G2 modules for these routers but cannot verify the WAN bandwidth these modules support. The reason I ask is that we originally looked at WAAS Express but the data sheet recommends a maximum of 6Mb WAN bandwidth for WAAS Express on the 2911. I cannot find any recommendation for the modules only that the module for the G1 was rated at 4Mb (according to the SRND)
For the ISR-G2's such as the 2911 I would suggest you look at the SM-SRE modules. For a 10Mb WAN you should be ok with a SM-SRE-700, which is targeted for 20Mb WAN links.
However, recommended WAN bandwidth is not limited in software or by any other system limit, but is rather provided as guidance for deployment sizing purposes.
The main limiting factor is number of expected concurrent TCP sessions to be optimized. There are two scale options with the SRE-700 (small or medium). The small will optimize up to 200 concurrent TCP sessions, and large will optimize up to 500 concurrent TCP sessions. So, if you have 20 users at this site, and assume 10 TCP connections per user you will already be at the limit (e.g. no room for user growth), and I would suggest you go with the medium option.
ACI Fabric start learning external remote IP’s locally on the Leaf switches . Due to this reason, traffic is locally dropped on Leaf Sw03 instead of going outside the fabric. This issue basically interrupted most of the External & Internal services be...
Transforming Day 2 Ops with Cisco Data Center Network Assurance and Insights
Live webinar: Network Insider Series
Wednesday, July 15, 202010:00 AM Pacific Standard Time (San Francisco, GTM -08:00) Driven by the growth of applications, deluge of data and t...
Hi All,i am going to deploy Hyperflex with Vmware for Testing Purposes.Are there CLI commands to do a factory reset of a new Hyperflex system and rebuild hyper flex again?is there any procedure for rebuild Hyperflex?