cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
453
Views
0
Helpful
2
Replies
Highlighted
Beginner

WAAS over EZVPN Backup

I am having an issue when a branch switch from their MPLS to

EZVPN Backup the WAAS traffic looks like its being blocked by the router

. I think iknow the reason why i just dont know how to fix it... TheStateful Inspection on the interface.

Multilink123 is up (if_number 68)

Corresponding hwidb fast_if_number 68

Corresponding hwidb firstsw->if_number 68

Internet address is

ICMP redirects are never sent

Per packet load-sharing is disabled

IP unicast RPF check is disabled

Input features: Stateful Inspection

Output features: Stateful Inspection, CCE Post NAT Classification, QoS Marking

Inbound access list is not set

Outbound access list is not set

IP policy routing is disabled

BGP based policy accounting on input is disabled

BGP based policy accounting on output is disabled

Interface is marked as point to point interface

Hardware idb is Multilink123

Fast switching type 7, interface type 105

IP CEF switching enabled

IP CEF switching turbo vector

IP Null turbo vector

IP prefix lookup IPv4 mtrie 8-8-8-8 optimized

Input fast flags 0x400000, Output fast flags 0x10014000

ifindex 66(66)

Slot  Slot unit 123 VC -1

Transmit limit accumulator 0x0 (0x0)

2 REPLIES 2
Highlighted
Enthusiast

Re: WAAS over EZVPN Backup

Hi,

If you have IOS FW features enabled on this router you will likely need to configurat ip inspect WAAS within the ZBF configuration.

Here is a good document on the interaction between WAAS and FWs

https://www.myciscocommunity.com/docs/DOC-1470

Regards,

Mike Korenbaum

Cisco Data Center PDI Help Desk

http://www.cisco.com/go/pdihelpdesk

Highlighted
Beginner

Re: WAAS over EZVPN Backup

Whe i have IP Inspect commands i know i can add "ip inspect WAAS enable" but this device has no IP Inspect commands only EZVPN Backup

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey

This widget could not be displayed.