04-05-2016 09:10 AM
Hi !
We are unable to ping WAAS WAE -7341 -k9 ip address!
i was check the cable and Reset also ! we are unable ping 1
We are getting system locator led indication on devices
regards
Asif
04-06-2016 11:57 AM
Hi Asif,
Access the device via console and check the alarms.
There may be many reason why u cannot ping. check if physical connection - Speed & duplex , vlan on switch side , IP default gateway etc.. are correctly configured.
Hami
04-08-2016 03:44 AM
Hi Hami
Thanks for support !
After Access the device via console and booting the device !
automatically start ping !
Asif
06-12-2016 11:34 PM
Hi Hami,
We need your help !
We have configuring the WAE - SM-SRE-710-K9 Module on CISCO2921/K9 - Version 15.4(3)M1 .
Problem is we are unable to ping our SM-SRE 710 module ip 10.22.12.5 .
Please check below config.
EX : interface SM1/0
description ***SM-SRE 710 ***
ip address 10.22.12.1 255.255.255.0
ip flow ingress
service-module ip address 10.22.12.5 255.255.255.0
service-module ip default-gateway 10.22.12.1
no keepalive
No sh
After configuration done Sh run con
interface SM1/0
description ***SM-SRE 710 ***
ip address 10.22.12.1 255.255.255.0
ip flow ingress
service-module fail-open
service-module ip address 10.22.12.5 255.255.255.0
service-module ip default-gateway 10.22.12.1
no keepalive
Asif
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: