Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about how to plan, design, and implement Cisco Overlay Transport Virtualization (OTV) in your Data Center Network with Cisco experts Anees Mohamed Abdulla and Pranav Doshi.
Anees Mohamed Abdulla is a network consulting engineer for Cisco Advanced Services, where he has been delivering plan, design, and implementation services for enterprise-class data center networks with leading technologies such as vPC, FabricPath, and OTV. He has 10 years of experience in the enterprise data center networking area and has carried various roles within Cisco such as LAN switching content engineer and LAN switching TAC engineer. He holds a bachelor's degree in electronics and communications and has a CCIE certification 18764 in routing and switching.
Pranav Doshi is a network consulting engineer for Cisco Advanced Services, where he has been delivering plan, design, and implementation services for enterprise-class data center networks with leading technologies such as vPC, FabricPath, and OTV. Pranav has experience in the enterprise data center networking area and has carried various roles within Cisco such as LAN switching TAC engineer and now network consulting engineer. He holds a bachelor's degree in electronics and communications and a master's degree in electrical engineering from the University of Southern California.
Remember to use the rating system to let Anees and Pranav know if you have received an adequate response.
Because of the volume expected during this event, Anees and Pranav might not be able to answer each question. Remember that you can continue the conversation on the Data Center, sub-community forum shortly after the event. This event lasts through August 23, 2013. Visit this forum often to view responses to your questions and the questions of other Cisco Support Community members.
Hello, I did a home connection using a wireless router and client. I have a wireless router, 2 desktop computers, a laptop with a wireless interface card, a television, a cable modem and a cable splitter.I have done all the configurations. I con...
We are looking to replace one Juniper QFX5200, Broadcom Tomahawk based switch with two 93180YC-FX/FX3 switches.On this Juniper switch, there is a GRE tunnel providing IPv4 and IPv6 transport, also running OSPF and OSPFv3. From Cisco Nexus 9000 N...
According to the whitepaper below
"...needs Cisco CSR 1000V Series routers in each region for traffic...
I am little curious about the vPC management design for Peer Keepalive Link.
According to the following URL which is traditional Nexus7000 Series vPC Best Practices.
Best Practices for Virtual Port Channels (vPC) on Cisco Nexus 700...
I have been reading vaious Cisco documents about ACI Hybrid Cloud setup (for Azure or AWS). However I am kind of confused from one doc to another. Here below are some confusing points hope someone could help clearify.
Whether using raw Internet OR ...