I have to say I was a bit skeptical about RDP/VNC support going to the portal then back to the TBA, but I have to say it's nothing short of phenomenal! This will make remote support 1000x easier, faster, and more reliable! Way to go Cisco!
Will we be getting static IP options on the TBA? We had a problem on our own LAN over the weekend that makes this an absolutely must-have. I was out of town until last night and our DHCP server faled to reboot after a power outage. All the rest of...
Marcos, I was setting up our Thunderbolt appliance for our in-house use today and it looks like I have a bad USB stick. I ended up using the USB stick from the 2nd appliance we have, but I’m going to need to get this bad one replaced. When you p...
We're just getting started with our Thunderbolt setup, so please bear with me as I have what are sure to be some questions that may have already been addressed at some point.Setup of the appliance actually went pretty easily on our network. I do hav...
If you add a VLAN with the same ID as one that was dynamically added via GVRP, the switch will show that the vlan was added, but you are not able to delete the VLAN unless you manually reset the page.Here are the screenshots detailing the steps:1. Sc...
Page 319 of the admin guide shows the path of the Network Configuration menu to be as follows:Switch Main Menu > System Configuration Menu > IP ConfigurationI think it should say :Switch Main Menu > System Configuration Menu > IP Configuration > Netw...
Hi,We've had some major Exchange issue and needed to start from scratch (yeah I know...)Anyway, since I don't have all the email addresses that were previously configured in the dead Exchange server, I was wondering if I could transfer all the unknow...
Since one client (1086) was down for a few days, came up and the firmware updated, I haven't been receiving e-mails for warnings and critical events. I checked the Event History to confirm entries were showing up, and some do.I also observed when the...
Two quereiesQuery 1. The SG300 Administrative guide states on page 55 that;"Poll Interval—Select to enable polling of the SNTP server for system time information. All SNTP servers that are registered for polling are polled, andthe clock is selected ...
Hi teamWhen i look at the operational state of IGMP snooping I see the following page;Note it shows IGMP snooping operational status is disabled.When i edit the VLAN1 parameters I see the following page;what is the significance of IGMP snooping oper...
The Administration manual doesn't indicate if RMON History, Event or Alarm table that you create, will survive a reboot. The manual doesn't indicate that changes or additions have to be saved, so that these options can survive a reboot.Step 4. is...
(From Steve DiStefano)After hitting REBOOT, the GUI
immediately returns success, but the switch has yet to even start to
reboot.Seems
very premature, no?
(From Dave Hornstein)How can i alter the static address
of the SF-300-48PI
can see no option in IE or Chrome for altering the static IP address
of the switch ?See attaches pictures.
Attachments:
...
(Posted by Dave Hornstein)HiHaving trouble creating a network specific ACL for my voice network 10.0.0.0 255.0.0.0 .Keep getting the following error in my broswer, see attached diagram, or if you can see it the diagram below.;Gotta admit the CLI acc...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
