cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
250
Views
0
Helpful
2
Replies
David Trad
Rising star

Unable to Apply Updated Credentials (SNMP/Management)

Hi Team,

I am unable to apply updated credentials when in the SNMP/Management section as per the screen shot.

Process taken:

  • Click on the "Red X" next to the SG-300 Switch for the admin access
  • Put in Username & Password
  • Click Apply and nothing happens - I can click it 20 times and it just wont budge, I have to click the "X" top right to close the dialogue screen

This results in not being able to update the credentials for admin access.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
1 ACCEPTED SOLUTION

Accepted Solutions
chucui
Cisco Employee

This bug was already fixed, should be good in next drop.

Thanks,

Brian

View solution in original post

2 REPLIES 2
chucui
Cisco Employee

This bug was already fixed, should be good in next drop.

Thanks,

Brian

View solution in original post

Hi Brian,

That is awesome news :)

Thanks for the feedback!

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
This widget could not be displayed.