Hi Team,
I am unable to apply updated credentials when in the SNMP/Management section as per the screen shot.
Process taken:
- Click on the "Red X" next to the SG-300 Switch for the admin access
- Put in Username & Password
- Click Apply and nothing happens - I can click it 20 times and it just wont budge, I have to click the "X" top right to close the dialogue screen
This results in not being able to update the credentials for admin access.
Cheers,
David.
Cheers,
David Trad.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
