Dialing *-Codes with the PAP2T

[fernando_parada]

Hello Community!

I really hope you can help me with this problem.

I´m trying to configure my dialplan to call the *77 Code, but I can´t. I already read the intructions in this site http://www.cisco.com/en/US/products/ps10033/products_qanda_item09186a0080a35a44.shtml

My current dialplan is (xx.|*xx.)

Do you have any ideas?

Thanks,

Fernando

[Daniele Giordano · Accepted solution]

Do you have removed the *77 code from "Vertical Service Activation Codes"?

If no, remove the code under Voice - Regional - Vertical Service Activation Codes menu.

This is my dial-plan. It enables ETSI service codes:

(**1x.|**2|*xx*x.|#31#x.|#[26]x#|4xxx|0|00|1xx|xxxxxxxxxxxx.)

Regards.

[fernando_parada]

Thank you very much! Everything works perfect now!