05-12-2016 03:58 PM - edited 03-21-2019 10:33 AM
Good Morning,
my new SPA122 V02 works fine with telefone on the line IO.
However, I was not able to connect the Samsung printer SCX-3405F so,
that the FAX works. The printer shows up with the ringing signal, but receiving
and sending is not working properly, e.g. sending is done but nothing
is received at the other site and vice versa.
There are so many options in the configuration setup of line 2 .. and I cannot
find out which is the right one.
However I've updated the FW to 1.4.1-002 already
What can I do ?
With thanks in advance & best regards, Uli
Solved! Go to Solution.
05-13-2016 08:08 AM
Hi Uli,
u-law or a-law depends on your country.
If I rememebr correctly u=USA and Western countries. A = Asian Countries.
I would disable echo cancellation.
As for T.38, I would not use it with this particular box. It consists in decoding the FAX tones and sending the actual data which is more effective for IP transmission but require a lot of CPU from the BOX and these Small Business units shold be spared.
Leave the pass-thouhg-method the way it is and configure the setting on your SIP registrar for only G711 traffic.
Francesco
05-13-2016 12:36 AM
Hi,
have you tried by using G711 as a fax pass through codec?
Francesco
05-13-2016 06:02 AM
Hello Francesco,
thank you very much for your fast reply !
There is G711u default setting and otherwise G711a ... what is the right one ?
For the pass-thrugh-method there is the choice betrween : None, NSE, ReInvite ... default is NSE
How should I configure the echo cancelling features ?
Furthermore there is T38 enabled .... is this correct or not ?
There are even more options resp. switches , hence a lot of permutations.... ;-)
How to proceed ?
Have a nice day, Uli
05-13-2016 08:08 AM
Hi Uli,
u-law or a-law depends on your country.
If I rememebr correctly u=USA and Western countries. A = Asian Countries.
I would disable echo cancellation.
As for T.38, I would not use it with this particular box. It consists in decoding the FAX tones and sending the actual data which is more effective for IP transmission but require a lot of CPU from the BOX and these Small Business units shold be spared.
Leave the pass-thouhg-method the way it is and configure the setting on your SIP registrar for only G711 traffic.
Francesco
05-16-2016 02:55 AM
Thanks a lot, Francesco,
.
the T.38 protocol had to be switshed off - it was default on. And the German Telecom
ist not supporting it at all.
The Codec had to be changed from default G711u (USA, Japan)
to G711a (Europe).
.
Now, FAX works fine !!!
.
cheers, Uli
02-18-2017 12:40 PM
Just for completeness ...
If I rememebr correctly u=USA and Western countries. A = Asian Countries.
G711a is "default" codec for most of countries, moreover, it's default codec used for international calls.
G711u is used in just few countries, namely US and Japan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide