cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

1211
Views
0
Helpful
2
Replies
pinokio_2000
Beginner

Linksys SPA2102 reboots at end of call

in most calls when I hang up , the device will reboot (all leds dies then red will flash, then regular boot sequence).

syslogd says: reboot reason : H0 (i.e. hardware reboot) which really doesn't help much.

the issue is that it won't send BYE upon such reboot.

I wonder if anyone else experience this.

It was like this since day 1.

I have unlocked Linksys SPA 2102 VOIP ATA with firmware 5.2.12 (newest) HW version 1.4.5 (I think)

device is set in NAT mode (I read some people recommend using it as bridge only) and device is chained behind a router.

no P2P activity in the background. in fact , minimal network activity.

I'm puzzled.

any help will do...

2 REPLIES 2
paolo bevilacqua
Hall of Fame Master

Try small business forum, this is for true cisco products only.

cahcahcah
Beginner

I can confirm that I'm experienceing the same issue. Even after factory reset and not configuring any lines, the ata reboots after just picking up and hanging up the phone.