Registering ATA187 in CME 9.1

[aldredbenedict]

Hello guys,

I am currently having difficulty in registering ATA187 in CME 9.1. I recently upgraded to 9.1 as it is mentioned inhttp://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme91spc.html
that CME 9.1 supports ATA187. It is said that the SIP firmware is supported, but I searched the SIP firmware for ATA187 in the Cisco website and found nothig

Any help will be appreciated.

[paolo bevilacqua]

ATA187 only supports SIP. It does not supports SCCP.

[aldredbenedict]

Yes, that I understand (I already mentioned it in my question). However I cannot find any ATA187 SIP firmware in the Cisco website. Or is it already embedded in the ATA hardware?

[paolo bevilacqua · Accepted solution]

Actually you asked about SIP firmware location, the answer is all firmware is SIP.

Al devices ships loaded with firmware. Sometime, it may be necessary to update it.

[aldredbenedict]

Thanks Paolo for the information. I have successfully registered the ATA187 by creating SIP endpoints.