I'm attempting to setup an SPA8000 with a single trunk to an ITSP account that has multiple DIDs, and I need each DID to route to a specific line port on the SPA, but I can't seem to figure out how to set such inbound call routing. Unfortunately, I cannot create sub accounts at my ITSP and set each line individually.
There was a post that was made on the Linksys forums about the same issue, but didn't have a helpful answer to it:
http://community.linksys.com/t5/VoIP-Routers/Routing-DIDs-to-Different-Ports-of-the-SPA8000-with-same-ITSP/m-p/213835
Can anyone provide guidance on how to route DIDs from a single trunk on the SPA to a specific line port?
Thanks!