SPA112 not taking Web Admin Password and Web Guest Password change

[Joe Meyer]

I am provisioning an SPA112 firmware version 1.4.1 for Broadsoft. I change the admin and guest password in the config file. When the SPA112 recovers I am still able to use the default login. Below are my changes. Any assistance would be greatly appreciated.

<Web_Login_Admin_Name>admin</Web_Login_Admin_Name>

<Web_Login_Admin_Password>569366</Web_Login_Admin_Password>

<Web_Login_Guest_Name>cisco</Web_Login_Guest_Name>

<Web_Login_Guest_Password>2656</Web_Login_Guest_Password>

[Dan Lukes]

Those commands are not root level commands. They are part of <router-configuration>...</router-configuration> block.

I would like to recommend you - save the SPA112 configuration (in XML form), make required changes then reload it back.

[Joe Meyer]

Dan,

Thank you for your response. I added this into the config file outside of the <router-configuration>...</router-configuration>

<Admin_Passwd ua="na">563966</Admin_Passwd>

<User_Password ua="rw">2656</User_Password>

Still did not take. 

I opened in web browser using this

http://172.16.127.48/admin/config.xml&xuser=admin&xpassword=admin

and the changes did not take. The ata does provision correctly except for admin password.

[Dan Lukes]

Both commands you mentioned doesn't exists on SPA112 at all, thus, you changed nothing and defaults apply.

[Joe Meyer]

Dan,

Would you happen to have the correct syntax for the SPA1x2 devices?

[Dan Lukes]

As advised already - save the current configuration to XML file. You will know all options known to SPA112 including correct context.