cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

14402
Views
5
Helpful
17
Replies
jon.cross
Beginner

SPA112 use with Call Manager

We have used ATA 186 devices with our Call Manager system for use with fax machines and analog phones in a manufacturing environment.  I am hopeful that the SPA112 can be used as a lower cost alternative to the older ATAs.  

I have searched for basic configuration information for use with Call Manager but haven't come across anything. 

Can these devices be used with Call Manager and is there basic information available on how to configure them?

Thanks.

17 REPLIES 17

Does Any One has this document can they upload, please.

1.) Create a local end user in CUCM and set digest credentials 

2.) Create a phone security profile for "Third Party SIP Device (Basic), set transport to UDP, check "Use Digest Credentials"

3.) Create a phone type Third Party SIP Device (Basic) using the "Internet" inferface mac of the SPA112 and configure all parameters as a normal device for your environment. 

4.) Set digest user to the user created in step 1

5.) Set SIP profile to the profile created in step 2

 

On the SPA 112

1.) Go to Voice 

2.) Go to "Line 1" 

3.) Set the parameters as follows

SIP Transport = UDP 

Proxy = IP of primary CUCM call processing node

Display Name = Extension

User ID = Extension

Password = Digest Password from CUCM user

Auth ID = User ID from CUCM user 

Set "Use Auth ID" to yes 

Reboot