cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

1199
Views
0
Helpful
1
Replies
Aaron Mount
Beginner

SPA122 boot-to-register time

Hello. Testing has shown that a factory-default SPA122, with minimal SIP registration details entered, takes about 68 seconds on average to boot up to a point where the attached phone could be used. The old SPA2102 took about 15 seconds to do the same thing.

Is this the norm for the new device? Has anyone else observed similar behavior?

1 ACCEPTED SOLUTION

Accepted Solutions
nseto
Frequent Contributor

This is normal.  The code base is different.

View solution in original post

1 REPLY 1
nseto
Frequent Contributor

This is normal.  The code base is different.

View solution in original post