We are currently experiencing an issue with the SPA122 [firmware ver. 1.2.0 (022)] whereby the following parameter does not seem to be working on the device.
We can see that the parameter is being changed (from No to Yes) through searching on the parameter list under:
However when 73738# and 1 is dialled the device will factory reset and lose all provisioned parameters.
Please advise on what can be done to prevent this from happening.
Go to Solution.
The functionality with the parameter has now been resolved in the latest pre-release firmware for the SPA122.
Please open a case with our support center who can then provide the firmware to you.
Information can be found at the following website:
Cisco Systems, Inc
View solution in original post
Apologies,the firmware version should read: firmware ver. 1.2.0 (020).
Any indication on when the next official release firmware will be out? Will it be some time this month?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: