cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3138
Views
5
Helpful
1
Replies

SPA2102 Caller ID issue

aemcomcco
Beginner
Beginner

We have replaced an old Cisco ATA188 SIP with a new SPA2102.

After this substitution we encountered a Caller ID problem.

The analog phone connected to SPA doesn't show the CID any more.

We have tried every possible combinations available on the SPA without success (Bellcore, ETSI FSK, ETSI DTMF, bell 202, v23, etc).

This is the working Cisco ATA 188 config:

RingOnOffTime 1,4,25

CallerIdMethod 0x00018066 hex  =  11 000000 001100 1 10 bin
bit 0-1=2 ETSI
bit 3=1 send after first ring

bit 3-8=12 maximum number of digits

bit 9-14=0 maximum number of chars

bit 15=1 send out ouf area if cli is unknown

bit 16=1 send privete if cli is restriceted

What are equivalent parameters of the SPA? Is there a bug on ETSI FSK Caller ID method?

Regards.

1 Accepted Solution

Accepted Solutions

Daniele Giordano
Rising star
Rising star

This is the working configuration:

RingCadence: 60(1/4)
Caller ID Method: Bellcore
Caller ID FSK Standard: bell 202
Idle Polarity: Reverse

View solution in original post

1 Reply 1

Daniele Giordano
Rising star
Rising star

This is the working configuration:

RingCadence: 60(1/4)
Caller ID Method: Bellcore
Caller ID FSK Standard: bell 202
Idle Polarity: Reverse

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers