02-18-2013 02:19 PM - edited 03-21-2019 09:59 AM
Hi,
Has anyone set up a SPA3102 as a simple gateway between the FXO PSTN line and an internal SIP PBX (Asterisk or similar)? I don't want the thing trying to act as a router; it will be on the same LAN segment & subnet as the PBX machine and just needs to provide a 2-way SIP trunk that's actually the PSTN line.
Would this work with just the WAN port connected, or perhaps with both ports on the same segment & subnet, or would that confuse it?
Thanks!
Jeff
Solved! Go to Solution.
02-18-2013 02:55 PM
Hi Jeff,
You could deploy it in bridge mode if you don't want it acting like a router:
Router tab > Lan Setup > Networking Service > Bridge
Regards,
Patrick---
02-18-2013 02:55 PM
Hi Jeff,
You could deploy it in bridge mode if you don't want it acting like a router:
Router tab > Lan Setup > Networking Service > Bridge
Regards,
Patrick---
02-22-2013 07:55 AM
That did the trick, thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: