SPA3102: SRTP + Non standard port for TLS

[mcampbellsmith]

Hi! 

I want to run a secure voip setup and need some information about the following.  I am connecting the SPA3102 to FreeSwitch which uses normal standards for TLS and SRTP.

1. How do enable and ensure that the SPA3102 uses SRTP? 
2. I am required to run TLS on a non-standard port.  If I use 5061 then I can get registered.  When I configure the SPA3102 to use the other port, it does not register.   There are no firewalls etc in the way at the moment while I am testing.   How do I do this and what is the supported port range?  I have tried SIP-Port and EXT-SIP-Port.

I have the latest firmware 5.1.10(GW)

Thanks

[andyholland]

Hello,

I've a requirement for a *lot* of ATA's that support TLS and sRTP - and I came accross this thread.

Is there any news on standard support for TLS and sRTP ?

Thanks

Adam

[anzzvvered]

Any news on this ???

The rep said its on their roadmap but no development schedule. That was 2 years back.

Looks like cisco really stinks here.