Buy or Renew
Buy or Renew
Cisco + Splunk: Itā€™s a new day for your data. Learn more.
Ā 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
Start a conversation
997
Views
0
Helpful
1
Replies

Urgent: SPA122 with Cisco UCM

servicedesk
Level 1
Level 1

ā€Ž09-10-2012 01:04 AM - edited ā€Ž03-21-2019 09:51 AM

Hi all

one of our old ATA's is faulty, hence the only one that we could get hold of as replacement is  SPA122 which we need to configure it urgently for security reasons.

I would to know if it is possible at all to manage/configure SPA122 via Cisco UCM? if yes, how so? any pointers?

Thank you very much in advance

Regards

Saman

0 Helpful
1 Reply 1

juan_diego_rodriguez
Level 1
Level 1

ā€Ž09-17-2012 02:25 PM

Unfortunately Is not possible to install the new SPA122 remotely, using the UCM; This because a couple of steps during the installation requires that you be on site.

I send you the installation steps for a SPA122. Is not a link from the Cisco web site, but it is a good site that explains the installation instructions step by step by pictures.

http://www.callcentric.com/support/device/cisco/spa112-spa122

If this answer was satisfactory for you, please mark the question as Answered.

Thank you

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents