WRP500 webconfig unreachable after setting to https

[Le Bernd]

Hello,

I've just finished the configuration and turned the management interface from http to https.

After that I don't get any webconfig answer anymore (website not available).

A portscan gives me open ports: 22, 443, 2869 and 49152. 

Is there any way to get the webconfig back beside a complete factory reset?

Thank you.

[Le Bernd]

This helped: https://supportforums.cisco.com/discussion/12532131/spa112-not-able-enter-webinterface

Well, well: I found an old opera browser somewhere and I could connect.

Will this be fixed in a future firmware release?

[Dan Lukes]

Only Cisco knows. But no Cisco's developer is reading this community. Call SMB support center and complain if you wish to make Cisco aware of the issue. But even in such case don't expect fast solution.

[Le Bernd]

Thank you for the suggestion. I had a chat with SMB support and they opened a ticket.