cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please note that Remote Expert Mobile announced end-of-life and support will end on February 28, 2022.
233
Views
1
Helpful
3
Replies
Highlighted
Beginner

Custom tabs-Need logged in user details

Hi Team,

I have a custom tab in my windows Jabber client and I need to populate the logged in user id in the url.

The sample url used in the custom tab is as given below, but the "UserID" value does not get populated.

Eg:  www.cisco.com/mywebapp.op?url=${UserID}   

Also are there other parameters available to get other user details?

Source:

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/Windows/9_2/JABW_BK_C9731738_00_jabber-windows-install-config/JABW_BK_C9731738_00_jabber-windows-install-config_chapter_0101.html#JABW_RF_U45614BC_00

Appreciate your help in advance.

Regards,

Everyone's tags (2)
3 REPLIES 3
Cisco Employee

Re: Custom tabs-Need logged in user details

Hi Yogesh,

    Sometimes this issue could be because of the bug CSCum05002 that mentions about UserID token is not replaced with the username of the logged in user in URLs. You can check the status of the bug with your CCO id.

Thanks and Regards,

Geevarghese

Beginner

Re: Custom tabs-Need logged in user details

Thanks for the info Geevarghese.

Are you aware of other parameters that can be used in addition to "UserID" ?

Regards,

Yogesh

Beginner

Re: Custom tabs-Need logged in user details

The problem was resolved with installation of the newer version on jabber windows client 9.7

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards
This widget could not be displayed.