Automation and Analytics

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Performance of GET Devices API

I am developing automation to compare a list of devices in a SQL database against the current list of devices in PI 3.1. My goal is to dynamically add/remove devices in PI based on what exists in this SQL database. In order to do the comparison, I ne...

smp by Enthusiast
  • 2239 Views
  • 5 replies
  • 0 Helpful votes

Sustainability in Open Source

Returning from OSCON, here is a worthwhile 15 minute presentation in the sustainability of open source. Danese Cooper does a great job summarizing the early history of open source and delivering the call to action for open source to deal appropriatel...

eckelcu by Cisco Employee
  • 1000 Views
  • 0 replies
  • 0 Helpful votes

APIC-EM Hub/Spoke

Hi Experts,I'm new to APIC-EM and would like clear up few confusing point that I'm not able to understand from the documentation.After deploying the APIC-EM in ESXi, I access the controller from management IP, then I install CSR1000v in ESXi which is...

usrana by Cisco Employee
  • 844 Views
  • 2 replies
  • 0 Helpful votes

Resolved! APIC-EM Grapevine behind NAT

I have a copy of APIC-EM 1.1.2 in a dev environment. There is a NAT device protecting the environment. I can log into the Grapevine console through the use of a static NAT to 14141 I get the console but no content. Just "error retrieving task informa...

twgraham by Beginner
  • 1525 Views
  • 4 replies
  • 0 Helpful votes

Resolved! APIC-EM EFT2 ACL API

Hi everyone,I have noticed that the EFT2 version is no longer available on DevNet, and a new GA release is out. But I can't seem to find the Policy Analysis support previously available on EFT2 in the GA +1. I was highly reliant on the ACL-related AP...

Resolved! Problem with Path Trace

Hello,I have problem with path trace, in one direction it can discover path of the flow and in another it can't. Problem is always in the same interface of the switch.What could be wrong with the configuration of the switch or path trace?Thank you in...

dgombovic by Beginner
  • 1606 Views
  • 7 replies
  • 1 Helpful votes

Resolved! How to create routing policy?

Hello,I would like to create routing policy that will route all IP phone traffic to one specific router. Every try in which I use categories or pathPreference results with error code "BadRequest" so I have few questions:-is there any API documentatio...

dgombovic by Beginner
  • 3146 Views
  • 7 replies
  • 1 Helpful votes

IP Device Tracking

I have configured APIC-EM in stand alone mode and have discovered a majority of my network devices. On many of these devices, I am unable to view host information within the APIC console. Port information is gathered successfully. I have verified tha...

TID_Orion by Beginner
  • 6567 Views
  • 19 replies
  • 0 Helpful votes

Location Group filtering

Hi. I have a pretty simple API call with a filter I'm trying to use with PI3.1. I want to return all Location Groups that contain the string "Region 2". This is the URI I'm trying, but the filter isn't working - I'm getting all the groups back. Am I ...

smp by Enthusiast
  • 838 Views
  • 1 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: