CiscoCMD auto reply prompt question

[Murciarules]

Hi there,

I would like to use automation a job using this command: "install remove inactive" with ciscoCMD

in multiple switches, however the program is stuck when prompt the question "Do you want to remove above files?" waiting for user insert "yes" or "y", is there a way using ciscocmd to auto reply yes o y without user interaction?

I followed the steps from this ticket https://community.cisco.com/t5/network-management/prime-infrastructure-cli-template-clean-ios-xe-not-working/m-p/4391897#M139777 without any help as user is using PI 3.9 Patch 1

Best regards.

[Alex Stevenson]

Hello @Murciarules,

I'm not a CiscoCMD expert. I was noticed in the doc Cisco Command The Ultimate Little Tool that it only runs on UNIX and Windows.

Perhaps you can run a command in it with one of the following, depending on your OS:

• yes (Unix) - https://en.wikipedia.org/wiki/Yes_(Unix)
• Auto Answer “Yes/No” to Prompt – PowerShell & CMD - https://www.shellhacks.com/auto-answer-yes-no-prompt-powershell-cmd/

Hope this helps!

 

[Murciarules]

Thanks @Alex Stevenson . i will have a look.