I need some advice or assistance to get PnP to deploy a complete switch stack configuration at the same times as I do a image upgrade.
I'm struggling getting the APIC-EM PnP to work as expected deploying the complete switch (WS-C3650-48PD) configuration. I've pre-provisioned switches to upgrade image to IOS-XE 16.3.3 and deploy a switch stack configuration where only the image is upgraded and the first half of the configuration is deployed. The odd thing is that PnP seems to think it is a success and says status Provisioned.
When I deploy the same configuration via CLI or do a new provision of the same switch stack but without image upgrade the complete configuration goes through without any errors so I assume the configuration is correct. I see no timeouts and we use 40 minutes timeout for image upgrade and 30 minutes for configuration deployment.
I have the same behavior on all switch stacks that the configuration deployment only deploy the interface configuration for the first two switches in the stack.
The interface configuration used is the following.
interface range GigabitEthernet2/0/1 - 48
switchport access vlan 42
switchport mode access
spanning-tree portfast
authentication control-direction in
authentication event fail action auth vlan 42
authentication event server dead action authorize vlan 42
authentication event no-response action authorize vlan 42
authentication event server alive action reinitialize
authentication host-mode multi-domain
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
authentication periodic
authentication timer reauthenticate server
mab
dot1x pae authenticator
dot1x timeout tx-period 3
dot1x timeout supp-timeout 10
dot1x max-req 3
spanning-tree bpduguard enable
switchport nonegotiate
storm-control broadcast level 0.5
storm-control multicast level 10
exit
!
interface range GigabitEthernet3/0/1 - 48
switchport access vlan 42
switchport mode access
spanning-tree portfast
authentication control-direction in
authentication event fail action auth vlan 42
authentication event server dead action authorize vlan 42
authentication event no-response action authorize vlan 42
authentication event server alive action reinitialize
authentication host-mode multi-domain
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
authentication periodic
authentication timer reauthenticate server
mab
dot1x pae authenticator
dot1x timeout tx-period 3
dot1x timeout supp-timeout 10
dot1x max-req 3
spanning-tree bpduguard enable
switchport nonegotiate
storm-control broadcast level 0.5
storm-control multicast level 10
exit
!
